![]() If that's what needs to happen then I'll do it, but I'm here to see what y'all think first. This seems like the best course of action, but the most expensive. ![]() I don't know what that looks like or if it's possible (or smart).ģ) Get a plumber to cut the deformed part out and sweat on an extension. I plan to do this temporarily since the existing Sharkbite fitting has lasted 12h without leaking, but I don't really like it for long-term.Ģ) Use some tool (?) to re-shape the existing copper pipe back up to the correct diameter. So I am seeking your wisdom, professionals and experienced amateur plumbers of Terry Love Forums: what should I do? Here are the options as I see them:ġ) Slap a Sharkbite angle stop on the pipe and call it a day. Thankfully, I had purchased a Sharkbite 1/2" cap in case things didn't go my way even more thankfully, it seems to be holding without leaking. Other than the change in OD, the pipe appears to be in good shape. This change in OD is apparent just by looking at or feeling the pipe, and is unfortunately close enough back to the wall that I don't think I can trim the deformed section of pipe and get a new compression fitting on (maaaaybe if I lose the escutcheon). Even if I tighten it down much farther than I should, it still just spins and I can pull right off the pipe. So much narrower, in fact, that a brand new compression fitting won't stay on (tried with two different ones). ![]() I was successful in removing the ferrule using the sleeve puller, however it appears that pulling the over-crimped ferrule over the length of the copper pipe has significantly altered the size of the pipe - it's narrower (OD is smaller). Since I couldn't get the leak to stop by tightening (duh), I decided to use a sleeve puller from HD to remove the old ferrule. Unfortunately, I didn't RTM (no excuses) and cranked the compression fitting pretty tight when I turned on the water there was a slight leak, so I cranked it down even farther (oof). I tried to attach a new compression-fit BrassCraft angle stop using the existing ferrule and compression nut. We have been Canadas premiere industrial supplier for. I got the old compression fitting off but the ferrule was stuck. Find your FAIRVIEW FITTING COMPRESSION SLEEVE 7/16 IN at Grainger Canada, formerly Acklands-Grainger. I recently decided to upgrade the old compression-fit multi-turn angle stop behind my toilet to an angle stop with a quarter-turn ball valve. Can I just put a Sharkbite angle stop on and be done, should I have a plumber come out and sweat on a new pipe, or is there another option? A temporary Sharkbite cap is holding and not leaking. Tl dr: Removal of an over-compressed ferrule seems to have deformed copper pipe to a smaller size such that a new compression fitting slides right off, even when tightened down.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |